特種鋼化玻璃加工范圍：3660mm*18000mm。

我司可加工的特種鋼化玻璃：雙曲特種鋼化玻璃、多曲特種鋼化玻璃、18米平彎超大特種鋼化玻璃等。

節能中空玻璃產品出現加工水印與氧化的問題怎么辦？

1、切割機刀頭處油量大，油污多。導致洗片階段清洗不徹底。建議采用專用的切割油，并減少切割油量，將其寬度控制在除膜范圍以內。2、磨邊機水箱內水質潤滑，微生物多。建議保養時加入八四消毒液。進行一遍水循環，消除水中微生物。3、在磨邊機末端增加一根光電感應沖水管，可輔助提高洗片機的清洗效率。4、洗片工段應采用純水清洗。且純水應至少8小時更換一次。磨片工段可采用普通自來水，建議使用洗片段更換出的純水。5、洗片完成后，在玻璃收片碼放部分，玻璃之間應采用軟木墊相互隔離。這樣做做的目的是，進一步風干內部水漬。6、洗片段末端，玻璃收片人員應戴口罩，防止人員唾液星沫飛濺。7、洗片工段的烘干機風箱入口處，應覆蓋無紡布或過濾棉，且應定期更換。原因如下：廠房內粉塵較大，長時間不清洗或更換會在玻璃表面形成帶粉塵的水印。8、洗片機毛刷應采用軟毛刷，控制轉速，毛刷應每周用高壓水槍沖洗一次。Low-E洗片速度為白玻的2/3。9、加強人員安全意識，部分工序操作和人員勞保用品需按要求使用。10、加強設備保養意識，需人員按照保養計劃定期保養和監督檢查。